How to fit a sink into a laminate benchtop

Supplied parts

Waste and overflow kit

Fixing clips

Self-adhesive sealing foam

Tools you’ll need

Screwdriver

Installation steps

1. Open the fixing clips

   Open the supplied fixing clips so they are ready to attach to the sink.

2. Attach the clips to the sink

   Snap the fixing clips into the oblong holes around the underside of the sink.

   Check that every clip is attached correctly and can move into position before fitting the sink.

3. Apply the sealing foam

   Apply the self-adhesive sealing foam around the underside edge of the sink.

   Keep the foam close to the edge and make sure there are no gaps in the seal.

   A large continuous bead of silicone adhesive can be used instead of the supplied sealing foam.

4. Secure the sink to the benchtop

   Carefully lower the sink into the benchtop cut-out and check that it is sitting in the correct position.

   From underneath the benchtop, tighten the fixing clips using a screwdriver. Work around the sink evenly so it pulls down securely against the benchtop.

   Check the sink position before fully tightening the clips. Tightening one area too quickly may pull the sink out of alignment.

5. Fit the waste and overflow

   Fit the waste and overflow kit following the instructions supplied with your sink.

   Check that all connections are fitted securely before using the sink.