In this guide — 4 steps
Included components
2 × tall end panels
Overhead cabinet
Two-drawer base cabinet
2 × microwave shelf panels
The example in this guide has a two-door overhead cabinet. Your tower may have a single door or flap-door cabinet instead, but the same assembly method applies.
Included hardware
L-brackets
28mm screws
16mm screws
45mm screws
Tools you’ll need
Impact driver
Pencil
Assembly steps
-
Fix the cabinets to the end panels
Position the base cabinet and overhead cabinet between the two tall end panels.
Screw through the cabinet sides and into the tall end panels using the supplied 28mm screws.
Use four 28mm screws on each side of each cabinet.
-
Assemble the microwave shelf
Position the microwave shelf bottom panel against the shelf back panel.
Install two 45mm screws through the bottom panel and into the shelf back panel.
-
Mark the oven height
Carefully position the oven inside the tower.
Use a pencil to mark the height of the top of the oven on the inside of both tall end panels.
Make sure the marks are level with each other before removing the oven and installing the shelf.
-
Install the microwave shelf
Position the L-brackets along the marked oven-height line.
Place the assembled microwave shelf above the brackets.
Use the 16mm screws to secure the L-brackets underneath and behind the microwave shelf, fixing it to the tall end panels.
Check that the shelf is level and securely supported before placing the microwave onto it.
Completed oven and microwave tower
